The driving of the motorcycle depends on the cable to control, the throttle, choke, clutch, front brake, etc., are inseparable from the cable, so the maintenance of the cable is crucial.

Grease the pull line often

Motorcycle through the sun and rain, pulling line is easy to rust, aging, dust and rain immersion is easy to make the line pulling inflexible or even broken.Therefore, it is an important project for motorcycle maintenance to pump oil for the pull line.The method is to remove the end of the line that needs to be filled with oil from the car after the night, wrap the outer skin of the line with transparent glue into a small funnel, and then drop a few drops of oil into the funnel, pay attention to the funnel must be vertical upward, the next morning you will find that the lower end of the line has oil seepage, indicating that the oil has penetrated the inside of the line.This kind of maintenance only needs to be carried out once a month, you can avoid the trouble of breaking down halfway.

Replace the defective pull wire in time

Some users of a motorcycle cable has broken a strand, but also in use.But do not know this will leave a hidden danger, if driving on the road, the pull line is broken, injured or yourself.To know that the clutch line is broken can not start, the throttle line is broken can not add oil, especially the throttle line is broken, stuck in the middle can not return to the oil,It is dangerous to cause flying cars.So we usually pay attention to check the various pull lines on the car, and replace them immediately when we find hidden dangers, so as not to be penny-wise and pound-foolish.